Nissan Maxima Service and Repair Manual: B terminal circuit

Power generation voltage variable control system operation inspection

Diagnosis Procedure CAUTION: When performing this inspection, always use a charged battery that has completed the battery inspection. (When the charging rate of the battery is low, the respons ...

L terminal circuit (open)

Description The "L" terminal circuit controls the charge warning lamp. The charge warning lamp turns ON when the ignition switch is set to ON or START. When the generator is providing sufficient ...

Other materials:

Washer level switch
Removal and Installation REMOVAL Position the RH front fender protector back. Refer to EXT-24, "Removal and Installation". Remove the engine under cover. Remove the RH front fender protector side cover. Refer to EXT-24, "Removal and Installation". Disconnect the front washer level ...

Precautions on seat belt usage
If you are wearing your seat belt properly adjusted and you are sitting upright and well back in your seat with both feet on the floor, your chances of being injured or killed in a collision and/or the severity of injury may be greatly reduced. NISSAN strongly encourages you and all of yo ...

In-vehicle sensor
Removal and Installation REMOVAL Remove the instrument lower panel LH. Refer to IP-19, "Removal and Installation". Remove the in-vehicle sensor screw and the in-vehicle sensor. INSTALLATION Installation is in the reverse order of removal. CAUTION: Make sure that the asp ...