Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
2. CHECK ENCODER CIRCUIT
Check encoder circuit.
Service data and specifications (SDS)
General Specification (Rear)
Wheel Alignment (Unladen*1)
*1: Fuel, engine coolant, and lubricants are full. Spare tire, jack, hand
tools, and mats are in designated positions. *2: 18" tire. *3: 19"
tire.
Ball Joint
Wheelarch Height (Unladen*1)
*1: Fuel, engine coolant, and lub ...
Subwoofer AMP
Removal and Installation
Subwoofer amp. and bracket
Subwoofer amp. bracket screws
REMOVAL
Disconnect the battery negative terminal. Refer to PG-67, "Removal
and Installation (Battery)".
Remove the parcel shelf finisher. Refer to INT-28, "Removal and
Installation". NOTE: The ...
AV branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the AV control unit for
damage, bend and loose connection (unit
side and connector side).
2.CHECK HARNESS FOR OPEN CIRC ...