Service data and specifications (SDS)Installing front license plate
Use the following steps to mount the front license
plate:
1. Make holes on the plastic finisher at the
location mark (small dimple) using a 5 mm
(0.20 in) drill. Apply light pressure to the drill.
Install the license plate holder using the two
screws provided with the holder.
2. Mount ...
Engine compartment
WARNING
Never use a fuse of a higher or lower
amperage rating than specified on the
fuse box cover. This could damage the
electrical system or electronic control
units or cause a fire.
If any electrical equipment does not come on,
check for an open fuse.
1. Be sure the ignition switch ...
Sunshade motor assembly
Removal and Installation
REMOVAL
CAUTION:
Before removing sunshade motor, check that glass lid is fully
closed.
After removing sunshade motor, do not attempt to rotate
sunshade motor assembly as a single unit
Close glass lid.
Remove the headlining. Refer to INT-33, "Removal and ...