Nissan Maxima Service and Repair Manual: Removal and installation

Front drive shaft
Inspection Check drive shaft mounting point and joint for looseness and other damage.  Check boot for cracks and other damage. CAUTION: Replace entire drive shaft assembly when nois ...

Front wheel hub
Removal and Installation Steering knuckle  Splash guard  Wheel hub and bearing assembly  Cotter pin REMOVAL  Remove wheel and tire using power tool. Refer to ...

Other materials:

C1729 vehicle speed signal
Description The vehicle speed signal is not being detected by the BCM. DTC Logic NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.  Activate and display TPMS transmitter IDs &nb ...

System temporarily unavailable
Condition A When the radar sensor picks up interference from another radar source, making it impossible to detect a vehicle ahead, the FEB system is automatically turned off. The FEB system warning light (orange) will illuminate. Action to take When the above conditions no longer exist, ...

Tel antenna
Removal and Installation REMOVAL Disconnect the battery negative terminal. Refer to PG-68, "Removal and Installation (Battery Tray)". Remove the rear parcel shelf finisher. Refer to INT-28, "Removal and Installation". Remove the Bluetooth antenna screw (A). Detach the Bluetooth a ...

Nissan Maxima Owners Manual

Nissan Maxima Service and Repair Manual

© 2017-2026 Copyright www.nimainfo.com
0.014