Nissan Maxima Service and Repair Manual: Front drive shaft

Inspection

  • Check drive shaft mounting point and joint for looseness and other damage.
  •  Check boot for cracks and other damage.

CAUTION: Replace entire drive shaft assembly when noise or vibration occur from drive shaft.

    Front wheel hub
    Inspection Move wheel hub and bearing assembly in the axial direction by hand. Make sure there is no looseness of wheel bearing. Rotate wheel hub and make sure there are no unusual noises or ...

    Removal and installation
    ...

    Other materials:

    Magnet clutch
    Description SYSTEM DESCRIPTION A/C auto amp. controls A/C compressor operation by ambient temperature and signal from ECM. Low Temperature Protection Control A/C auto amp. will turn the A/C compressor ON or OFF as determined by a signal detected by ambient sensor. When ambient temperatur ...

    Compressor control function
    Description PRINCIPLE OF OPERATION A/C compressor is not activated. Functional circuit diagram CAN (1): A/C switch signal : Blower fan motor switch signal CAN (2): A/C compressor request signal RX: A/C switch signal : Fan ON signal : Defroster signal Functional initial inspection chart ...

    RGB area (YS) signal circuit
    Description Transmits the display area of RGB image displayed by AV control unit with RGB area (YS) signal to display unit. Diagnosis Procedure 1.CHECK CONTINUITY RGB AREA (YS) SIGNAL CIRCUIT Turn ignition switch OFF. Disconnect display unit connector M141 and AV control unit con ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.016