Nissan Maxima Service and Repair Manual: Front wheel hub
Inspection
- Move wheel hub and bearing assembly in the axial direction by hand. Make sure there is no looseness of wheel bearing.
- Rotate wheel hub and make sure there are no unusual noises or other irregular conditions. If there are any irregular noises or conditions, replace wheel hub and bearing assembly.
Front drive shaft
Inspection
Check drive shaft mounting point and joint for looseness and other
damage.
Check boot for cracks and other damage.
CAUTION: Replace entire drive shaft assembly
when nois ...
Other materials:
C1142 press sen circuit
Description
The pressure sensor converts the brake fluid pressure to an electric signal
and transmits it to the ABS actuator
and electric unit (control unit). (The pressure sensor is integrated in the ABS
actuator and electric unit (control
unit).)
DTC Logic
DTC DETECTION LOGIC
DTC C ...
IPDM-E branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the IPDM E/R for damage,
bend and loose connection (unit side
and connector side).
2.CHECK HARNESS FOR OPEN CIRCUIT
...
Chassis & body maintenance
Abbreviations: I = Inspect and correct or replace as necessary, R =
Replace,
NOTE:
Maintenance items with " " should be performed more frequently according
to "Maintenance under severe driving conditions".
(1) If towing a trailer, using a camper or a car-top carrier or driving on ro ...
Nissan Maxima Owners Manual
- Illustrated table of contents
- Safety-Seats, seat belts and supplemental restraint system
- Instruments and controls
- Pre-driving checks and adjustments
- Monitor, climate, audio, phone and voice recognition systems
- Starting and driving
- In case of emergency
- Appearance and care
- Do-it-yourself
- Maintenance and schedules
- Technical and consumer information
Nissan Maxima Service and Repair Manual
0.0061