Nissan Maxima Service and Repair Manual: Suspension

Removal and installation

WHEEL HUB Removal and Installation Knuckle Baffle plate  Wheel hub assembly  Brake rotor Wheel nut Anchor block Wheel sensor Parking brake cable Refer to PB-6, ...

Front suspension

...

Other materials:

P0139, P0159 HO2S2
Description The heated oxygen sensor 2, after three way catalyst (manifold), monitors the oxygen level in the exhaust gas on each bank. Even if switching characteristics of the air fuel ratio (A/F) sensor 1 are shifted, the air-fuel ratio is controlled to stoichiometric, by the signal ...

Shock absorber
Removal and Installation REMOVAL Remove the rear wheel and tire using power tool. Refer to WT-60, "Adjustment". Set a jack under rear lower link to relieve the rear suspension spring tension. Remove the rear shock absorber lower nut and bolt with a power tool. Gradually lower t ...

U1000 Can comm circuit
Description DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by performing the Self Diagnostic Result procedure. Diagnosis Proc ...