Nissan Maxima Service and Repair Manual: Road wheels & tires

Service data and specifications (SDS)

General Specification (Rear) Wheel Alignment (Unladen*1) *1: Fuel, engine coolant, and lubricants are full. Spare tire, jack, hand tools, and mats are in designated positions. *2: 18" tire ...

Basic inspection

...

Other materials:

Squeak and rattle trouble diagnoses
Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer's comments; refer to RF-144, "Diagnos ...

Line pressure test
Inspection and Judgment INSPECTION Line Pressure Test Procedure  Inspect the amount of engine oil and replenish if necessary.  Drive the car for about 10 minutes to warm it up so that the CVT fluid reaches in the range of 50 to 80C (122 to 176F). Then inspect the ...

Disk eject signal circuit
Description The eject signal is output to AV control unit when the eject switch of A/C and AV switch assembly is pressed. Diagnosis Procedure 1.CHECK CONTINUITY DISK EJECT SIGNAL CIRCUIT Turn ignition switch OFF. Disconnect A/C and AV switch assembly connector M98 and AV control un ...