Nissan Maxima Service and Repair Manual: System description

Inspection and adjustment

Preliminary Check NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.  Activate and ...

TPMS

System Diagram System Description DESCRIPTION During driving, the tire pressure monitoring system receives the signal transmitted from the transmitter installed in each wheel, and turns on the ...

Other materials:

B2618 BCM
Description BCM controls the various electrical components and simultaneously supplies power according to the power supply position. BCM checks the power supply position internally. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2618 is displayed with DTC U1000, first perform the trou ...

P0840 transmission fluid pressure SEN/SW A
The secondary pressure sensor detects secondary pressure of CVT and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds b ...

Body sealing
Description The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of sealant and not to allow other unaffected parts to come into con ...