Nissan Maxima Owners Manual: Monitor, climate, audio, phone and voice recognition systems

System operation

The automatic drive positioner system will not work or will stop operating under the following conditions: When the vehicle speed is above 0 mph (0 km/h) or 4 mph (7km/h) for some limited fu ...

RearView Monitor (if so equipped)

1. CAMERA button WARNING Failure to follow the warnings and instructions for proper use of the Rear- View Monitor system could result in serious injury or death. RearView Monitor is a ...

Other materials:

P0840 transmission fluid pressure SEN/SW A
The secondary pressure sensor detects secondary pressure of CVT and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds b ...

Memory storage function
Two positions for the driver's seat, steering column (if so equipped), and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Place the ignition in the ON or ACC position (The vehicle should be stopped while setting ...

P1564 ASCD steering switch
Description ASCD steering switch has variant values of electrical resistance for each button. ECM reads voltage variation of switch, and determines which button is operated. Refer to EC-68, "System Diagram" for the ASCD function. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P156 ...