Nissan Maxima Owners Manual: Manual operation
Fan speed control
Press the 
fan speed control
buttons to
manually control the fan speed.
Press the AUTO button to return to automatic control of the fan speed.
Air recirculation
Press the
air recirculation
button to recirculate
interior air inside the vehicle. The 
indicator light on the button will come on.
The air recirculation cannot be activated when
the air conditioner is in the 
front
defrosting
mode.
Fresh air intake
Press the 
fresh air intake
button to draw
outside air into the passenger compartment.
Air flow control
Pressing the MODE button manually controls air flow and selects the air outlet:
- Air flows mainly from center
and
side vents
- Air flows mainly from center
and
side vents and foot outlets.
- Air flows mainly from foot
outlets
and partly from defroster.
- Air flows mainly from defroster
and foot outlets.
To turn system off
Press the ON-OFF button.
Rear window and outside mirror (if so equipped) defroster switch
For additional information, refer to "Rear window and outside mirror (if so equipped) defroster switch" in the "Instruments and controls" section of this manual.
Dehumidified defrosting or defogging
1. Press the front
defroster button on.
2. Turn the temperature control dial to set the
maximum temperature to aid in defrosting or
defogging.
To quickly remove ice from the outside o ...
Operating tips
When the engine coolant temperature and
outside air temperature are low, the air flow
from the foot outlets may not operate for a
maximum of 150 seconds. However, this is
not a malfunction. ...
Other materials:
Opening windows
The Intelligent Key allows you to simultaneously
open windows equipped with automatic operation.
To open the windows, press and hold
the button on the Intelligent
Key for
longer than 3 seconds.
The door windows will lower while holding down
the button on the Intelligent Key.
NOTE: ...
P1611 ID discord, IMMU-ECM
Description
BCM performs the ID verification with ECM that allows the
engine to start. Start the engine if the ID is OK.
ECM prevents the engine from starting if the ID is not registered. BCM starts
the communication with ECM if
ignition switch is turned ON.
DTC Logic
DTC DETECTION LOGIC ...
Service data and specifications (SDS)
General Specification (Rear)
Wheel Alignment (Unladen*1)
*1: Fuel, engine coolant, and lubricants are full. Spare tire, jack, hand
tools, and mats are in designated positions. *2: 18" tire. *3: 19"
tire.
Ball Joint
Wheelarch Height (Unladen*1)
*1: Fuel, engine coolant, and lub ...
Nissan Maxima Owners Manual
- Illustrated table of contents
- Safety-Seats, seat belts and supplemental restraint system
- Instruments and controls
- Pre-driving checks and adjustments
- Monitor, climate, audio, phone and voice recognition systems
- Starting and driving
- In case of emergency
- Appearance and care
- Do-it-yourself
- Maintenance and schedules
- Technical and consumer information
Nissan Maxima Service and Repair Manual
0.0167