Nissan Maxima Service and Repair Manual: Unit disassembly and assembly

Rear regulator

Rear Door Glass Regulator REMOVAL Remove the rear door finisher. Refer to INT-21, "Removal and Installation". Position aside the vapor barrier. Temporarily reconnect the power window ...

Power window control system

...

Other materials:

P1805 brake switch
Description Brake switch signal is applied to the ECM via the stop lamp switch when the brake pedal is depressed. This signal is used mainly to decrease the engine speed when the vehicle is being driver. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATI ...

On board diagnostic (OBD) system
Trouble Diagnosis Introduction CAUTION: Do not use electrical test equipment on any circuit related to the SRS unless instructed to do so inthis Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harness connectors. Do not attempt to repair, splice or modify ...

Front fog lamp aiming adjustment
Description PREPARATION BEFORE ADJUSTING NOTE: For details, refer to the regulations in your area. Before performing aiming adjustment, check the following. Adjust the tire pressure to specification. Position vehicle and screen on level surface. Ensure there is no load in vehicle other ...