Nissan Maxima Service and Repair Manual: Glass & window system

Push button ignition switch

Removal and Installation REMOVAL  Remove push-button ignition switch from cluster lid A, using a suitable tool.  Disconnect harness connector from push-button ignition ...

Precaution

PRECAUTIONS Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used alo ...

Other materials:

Power supply and ground circuit
Description EPS system functions by ignition power supply. Diagnosis Procedure 1.CHECK POWER SUPPLY Turn the ignition switch OFF. Disconnect power steering control unit connector. Turn the ignition switch ON. Check voltage between power steering control unit connectorM59 terminal 3 ...

Operating tips
When the engine coolant temperature and outside air temperature are low, the air flow from the foot outlets may not operate for a maximum of 150 seconds. However, this is not a malfunction. After the coolant temperature warms up, air flow from the foot outlets will operate normally. ...

B2608 starter relay
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2608 is displ ...