Nissan Maxima Service and Repair Manual: Restraints

Unit removal and installation

EPS CONTROL UNIT Removal and Ins REMOVAL Disconnect negative battery terminal. Refer to PG-67, "Removal and Installation (Battery)". Remove audio display unit. Refer to AV-73, "Removal an ...

Seat belt system

...

Other materials:

Engine block heater (if so equipped)
Engine block heaters are used to assist with cold temperature starting. The engine block heater should be used when the outside temperature is 20F (-7C) or lower. WARNING Do not use your engine block heater with an ungrounded electrical system or a 2-pronged adapter. You can be serious ...

Lifting switch (rear)
Description Lifting switch (rear) is equipped to the power seat switch LH on the seat frame. The operation signal is inputted to the driver seat control unit when the lifting switch (rear) is operated. Component Function Check 1. CHECK FUNCTION Select "LIFT RR SW-UP", "LIFT RR SW-DN" in " ...

Headlamp (HI) circuit
Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp high relay based on inputs from the BCM over the CAN communication lines. When the headlamp high relay is energized, power flows through fuses 48 and 49, located in the IPDM E/R. Power then flow ...