Nissan Maxima Service and Repair Manual: SRS airbag

Top tether strap child restraint

Removal and Installation NOTE: The top tether strap child restraint is a built-in part of the vehicle structure and is not serviceable. : Front ...

Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a fro ...

Other materials:

Sunshade motor assembly
Removal and Installation REMOVAL CAUTION: Before removing sunshade motor, check that glass lid is fully closed. After removing sunshade motor, do not attempt to rotate sunshade motor assembly as a single unit Close glass lid. Remove the headlining. Refer to INT-33, "Removal and ...

Power supply and ground circuit
BCM (BODY CONTROL MODULE) BCM (BODY CONTROL MODULE) : Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuses or fusible link are blown. 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF. Disconnect BCM. Check voltage between BCM harness connector and ...

Condenser
Removal and Installation REMOVAL Remove the rear pillar finisher LH. Refer to INT-24, "Removal and Installation". Disconnect the harness connector, remove bolt (A), and then remove condenser (1) from the vehicle body. INSTALLATION Installation is in the reverse order of ...