Removal and Installation
REMOVAL
INSTALLATION
Installation is in the reverse order of removal.
P1800 vias control solenoid valve 1
Description
The VIAS control solenoid valve 1 cuts the intake manifold vacuum signal for
power valve 1 control. It
responds to ON/OFF signals from the ECM. When the solenoid is OFF, the vacuum
signal from the intake
manifold is cut. When the ECM sends an ON signal the coil pulls the plunger ...
Front wheel hub
Removal and Installation
Steering knuckle
Splash guard
Wheel hub and bearing assembly
Cotter pin
REMOVAL
Remove wheel and tire using power tool. Refer to WT-60,
"Adjustment".
Remove wheel sensor from steering knuckle. Refer to BRC-102,
"Rem ...
Diagnosis sensor unit
Removal and Installation
WARNING:
Before servicing, turn ignition switch OFF, disconnect both
battery terminals and wait at least 3 minutes.
Before disconnecting the air bag sensor unit harness
connector, be sure to disconnect the harness connector of each air bag
module and pre-tens ...