Nissan Maxima Service and Repair Manual: DTC/circuit diagnosis

On board diagnostic (OBD) system

Trouble Diagnosis Introduction CAUTION: Do not use electrical test equipment on any circuit related to the SRS unless instructed to do so inthis Service Manual. SRS wiring harnesses can be ...

B1049 - B1052, B1054 - B1057 driver airbag module

Description DTC B1049 - B1052, B1054 - B1057 DRIVER AIRBAG MODULE The driver air bag module is dual stage and wired to the air bag diagnosis sensor unit through the spiral cable.The air bag diagno ...

Other materials:

B260f engine status
Description BCM receives the engine status signal from ECM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B260F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-29, "DTC Logic". If DTC B260F is displayed with D ...

Electric ignition system
System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This signal is sent to the ECM via the CAN communication line. *2: ECM determines the start signal status by the signals of engine speed and battery voltage. SYSTEM DESCRIPTION Ignition order: 1 - 2 - 3 - 4 - 5 - 6 The ...

Both side front fog lamps are not turned on
Description The front fog lamps do not turn ON in any setting. Diagnosis Procedure 1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION Check the combination switch (lighting and turn signal switch). 2.CHECK FRONT FOG LAMP REQUEST SIGNAL INPUT CONSULT DATA MONITOR Select "FR F ...