DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1. DTC CONFIRMATION
Diagnosis Procedure
1. CHECK BATTERY VOLTAGE
Check battery voltage
2. CHECK POWER SUPPLY CIRCUIT AND GROUND CIRCUIT
Check BCM power supply circuit and ground circuit.
Special Repair Requirement
1. REQUIRED WORK WHEN REPLACING BCM
Initialize control unit.
U0415 Vehicle speed sig
Power supply and ground circuitRear combination lamp
Disassembly and Assembly
Rear combination lamp
Rear side marker lamp socket
Rear side marker lamp bulb
Rear turn signal lamp socket
Rear turn signal lamp bulb
Back-up lamp socket
Back-up lamp bulb
DISASSEMBLY
Rotate the rear side marker lamp socket counterclockwise and ...
Unit disassembly and assembly
COOLING FAN
Disassembly and Assembly of Cooling Fan
Fan blade
Fan shroud
Fan motor
DISASSEMBLY
Remove fan blade nut.
Remove fan blade from fan motor.
Remove fan motor bolts and remove fan motor from fan shroud.
ASSEMBLY
Assembly is in the reverse order of disassembly. ...
ABS function does not operate
Diagnosis Procedure
CAUTION:
ABS does not operate when speed is 10 km/h (6 MPH) or lower.
1.CHECK ABS WARNING LAMP DISPLAY
Make sure that the ABS warning lamp turns OFF after ignition switch is turned
on or when driving
2.CHECK WHEEL SENSOR AND SENSOR ROTOR
Check the following:
Wheel se ...