Nissan Maxima Service and Repair Manual: U0415 Vehicle speed sig

Description

U0415 is displayed if any unusual condition is present in the reception status of the vehicle speed signal from the ABS actuator and electric unit (control unit).

DTC Logic

DTC DETECTION LOGIC

Nissan Maxima. DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1. DTC CONFIRMATION

  1. Erase the DTC.
  2. Turn ignition switch OFF.
  3. Perform the "SELF-DIAG RESULTS" of BCM with CONSULT, after the ignition switch has been turned ON for 2 seconds or more.

Diagnosis Procedure

1. ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF DIAGNOSTIC RESULT

Perform Self Diagnostic Result of ABS actuator and electric unit (control unit) with CONSULT

2. CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND

CIRCUIT

Check ABS actuator and electric unit (control unit) power and ground

3. COMBINATION METER SELF DIAGNOSTIC RESULT

Perform Self Diagnostic Result of METER M&A with CONSULT

    U1010 Control unit (CAN)
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1. REPLACE BCM When DTC U1010 is detected, replace BCM. ...

    B2562 Low voltage
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. DTC CONFIRMATION Erase DTC. Turn ignition switch OFF. Perform the "SELF-DIAG RESULTS" of BCM with CONSULT, after th ...

    Other materials:

    U1001 can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each ...

    B257B, B257C ambient sensor
    Description COMPONENT DESCRIPTION Ambient Sensor The ambient sensor (1) is installed to the front bumper reinforcement. It detects ambient temperature and converts it into a resistance value which is then input into the A/C auto amp. Ambient Sensor Circuit AMBIENT TEMPERATUR ...

    Sunload sensor
    Removal and Installation REMOVAL Remove the front LH speaker grille from the instrument panel. Refer to IP-10, "Exploded View". Disconnect the harness connector from the sunload sensor. Release the sunload sensor tabs and remove the sunload sensor (1) from the front LH speake ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0111