Nissan Maxima Service and Repair Manual: C1729 vehicle speed signal

Description

The vehicle speed signal is not being detected by the BCM.

DTC Logic

NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

  •  Activate and display TPMS transmitter IDs
  •  Display tire pressure reported by the TPMS transmitter
  • - Read TPMS DTCs
  •  Register TPMS transmitter IDs

DTC DETECTION LOGIC

Nissan Maxima. DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.CHECK SELF-DIAGNOSTIC RESULTS

  1. On "SELECT DIAG MODE", select the "SELF-DIAG RESULT" screen.
  2. Check display contents on "SELF DIAG RESULT" screen.

Diagnosis Procedure

NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

  •  Activate and display TPMS transmitter IDs
  •  Display tire pressure reported by the TPMS transmitter
  •  Read TPMS DTCs
  •  Register TPMS transmitter IDs

MALFUNCTION CODE NO. 52 (DTC C1729)

1.CHECK SELF-DIAGNOSTIC RESULTS

  1. On "SELECT DIAG MODE", select the "SELF-DIAG RESULT" screen.
  2. Check display contents on "SELF DIAG RESULT" screen.

Special Repair Requirement

Perform preliminary check.

    C1716 - C1719 transmitter pressure malfunction
    Description Air pressure data from one or more transmitters is out of range. DTC Logic NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal ...

    C1734 control unit
    Description An internal malfunction has been detected in the TPMS function of the BCM. DTC Logic NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to t ...

    Other materials:

    P1551, P1552 battery current sensor
    Description The power generation voltage variable control enables fuel consumption to be decreased by reducing the engine load which is caused by the power generation of the generator. The battery current sensor is installed to the battery cable at the negative terminal. The sensor measures ...

    DLC branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side). 2.CHECK HARNESS FOR OP ...

    Front washer
    WASHER TUBE WASHER TUBE : Layout Washer nozzle (LH) Washer nozzle hose (LH) Washer nozzle (RH) Washer nozzle hose (RH) Y-tube connector Washer tank hose Washer tank Tube connectors Clip FRONT WASHER NOZZLE FRONT WASHER NOZZLE : Removal and Installation REMOVAL ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0102