Nissan Maxima Service and Repair Manual: DTC/circuit diagnosis

Diagnosis system (BCM)

CONSULT Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions. CONS ...

C1708 - C1711 data from transmitter not being received

Description Tire pressure data for one or more transmitters is not being received by the BCM. DTC Logic NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. R ...

Other materials:

Vehicle Dynamic Control (VDC) off switch
The vehicle should be driven with the VDC system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The engine speed will be reduced even if the accelerator is depressed to the floor. If maximum engine po ...

Glove box
Open the glove box by pulling the handle. Use the master key when locking or unlocking the glove box. There is a trunk cancel switch in the glove box. For additional information, refer to "Cancel switch" in the "Pre-driving checks and adjustments" section of this manual. WARNING Keep g ...

Intelligent key battery
Removal and Installation Release the lock knob at the back of the Intelligent Key and remove the mechanical key. Insert a suitable tool (A) wrapped with a cloth into the slit of the corner and twist it to separate the upper part from the lower part. Replace the battery with new o ...