Nissan Maxima Service and Repair Manual: DTC/Circuit diagnosis

Diagnosis system (BCM)

COMMON ITEM COMMON ITEM : CONSULT Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. Direct Diagnostic Mode De ...

U1000 Can comm circuit

Description DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic sy ...

Other materials:

C1156 ST ANG sen com cir
Description The steering angle sensor is connected to the ABS actuator and electric unit (control unit) in addition to CAN lines. CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communica ...

Diagnosis and repair workflow
Work Flow OVERALL SEQUENCE 1.GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred). 2.CHECK DTC WITH BCM AND IPDM E/R Check "Self Diagnostic Result" with CONSULT. Perform ...

Evaporative emission system
System Diagram System Description *1: ECM determines the start signal status by the signals of engine speed and battery voltage. *2: This signal is sent to the ECM via the CAN communication line. SYSTEM DESCRIPTION The evaporative emission system is used to reduce hydrocarbons emitte ...