"AIR BAG" Warning Lamp Does Not Turn Off
DIAGNOSTIC PROCEDURE
1.CHECK CONDITION OF AIR BAG MODULE
Inspect for any deployed air bag modules or seat belt pre-tensioners.
2.CHECK THE AIR BAG FUSE
Check 10A fuse [No. 2, located in the fuse block (J/B)].
3.CHECK AIR BAG FUSE AGAIN
Replace 10A fuse [No. 2, located in the fuse block (J/B)] and turn ignition switch ON.
4.CHECK AIR BAG DIAGNOSIS SENSOR UNIT
Connect CONSULT.
5.CHECK HARNESS CONNECTION
Check for loose connections between the combination meter and the air bag diagnosis sensor unit.
"AIR BAG" Warning Lamp Does Not Turn On
DIAGNOSTIC PROCEDURE
1.CHECK METER FUSE
Check the 10A fuse [No. 4, located in the fuse block (J/B)].
2.REPLACE METER FUSE AND CHECK AGAIN
Replace 10A fuse [No. 4, located in the fuse block (J/B)] and turn ignition switch ON.
3.CHECK HARNESS CONNECTIONS BETWEEN AIR BAG DIAGNOSIS SENSOR UNIT AND
COMBINATION
METER
Inspect the harness and connectors between the air bag diagnosis sensor unit and the combination meter.
4.CHECK COMBINATION METER
Disconnect the air bag diagnosis sensor unit harness connectors and turn ignition switch ON.
Passenger seat belt warning systemIf your vehicle overheats
If your vehicle is overheating (indicated by an
extremely high temperature gauge reading) or if
you feel a lack of engine power, detect abnormal
noise, etc., take the following steps.
WARNING
Do not continue to drive if your vehicle
overheats. Doing so could cause engine
damage or a vehi ...
Inspection and adjustment
BASIC INSPECTION
BASIC INSPECTION : Special Repair Requirement
1.INSPECTION START
Check service records for any recent repairs that may indicate a
related malfunction, or a current need for
scheduled maintenance.
Open engine hood and check the following:
Harness connectors fo ...
Front door speaker
Description
The AV control unit sends audio signals to the front door speakers using the
front door speaker circuits.
Diagnosis Procedure
1.CONNECTOR CHECK
Check the AV control unit and speaker connectors for the following:
Proper connection
Damage
Disconnected or loose terminals
2. ...