Seat Belt Warning System Does Not Function
1.SEAT BELT WARNING LIGHT
Turn ignition switch ON.
2.SEAT BELT BUCKLE LH
Fasten the seat belt buckle LH.
3.OCCUPANT CLASSIFICATION SYSTEM
Have a helper sit in the passenger seat
4.SEAT BELT BUCKLE RH
Fasten the seat belt buckle RH.
SRS air bag system
PrecautionReprogramming a single HomeLink button
To reprogram a HomeLink Universal Transceiver
button, complete the following:
1. Press and hold the desired HomeLink button.
DO NOT release the button.
2. The indicator light will begin to flash after
20 seconds. Without releasing the
HomeLink button, proceed with "Programming
HomeLink" - ...
Radius rod
Removal and Installation
Removal
Remove the rear wheel and tire using power tool. Refer to WT-60,
"Adjustment".
Remove the radius rod nut and bolt from the rear axle housing
using power tools.
Remove the radius rod bolt from the rear suspension member using power
tools.
Remove th ...
Headlamp (LO) circuit
Description
The IPDM E/R (intelligent power distribution module engine room) controls the
headlamp low relay based on inputs from the BCM over the CAN communication
lines. When the headlamp low relay is energized, power flows through fuses 51
and 52, located in the IPDM E/R. Power then flows ...