Wiring diagram
SRS air bag systemB2608 starter relay
Description
Located in IPDM E/R, it runs the starter motor. The
starter relay is turned ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC B2608 is displ ...
Center speaker
Removal and Installation
REMOVAL
Remove the center speaker grille, using a suitable tool.
Remove the center speaker screws (A).
Pull out the center speaker (1), disconnect the harness connector
from the center speaker and remove.
INSTALLATION
Installation is in the reverse order of ...
Power steering oil pump
Inspection
CAUTION: Make sure that belt tension is
normal before starting the following procedure.
Connect the Tool between oil pump discharge connector and
high-pressure hose. Bleed air from the hydraulic circuit while opening
the shut-off valve fully. Refer to ST-12, "Inspection".
...