Description
Light reminder warning does not sound even though headlamp is illuminated.
Diagnosis Procedure
1. CHECK COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) OPERATION
Check that the headlamps operate normally by operating the combination switch (lighting and turn signal switch).
2. CHECK FRONT DOOR SWITCH LH SIGNAL CIRCUIT
Perform inspection of the front door switch LH signal circuit. Refer to DLK-67, "Diagnosis Procedure".
3. CHECK FRONT DOOR SWITCH LH
Perform a unit inspection for the front door switch LH. Refer to DLK-69, "Component Inspection".
The parking brake release warning continues sounding, or does not sound
The seat belt warning continues sounding, or does not soundBasic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow (With EXP-800 NI or GR8-1200 NI)
CHARGING SYSTEM DIAGNOSIS WITH EXP-800 NI OR GR8-1200 NI
To test the charging system, use the following special service tools:
EXP-800 NI Battery and electrical diagnostic analyzer
GR8-1200 NI Multitasking battery and ...
Rear door speaker
Removal and Installation
REMOVAL
Remove the rear door finisher. Refer to INT-21, "Removal and
Installation".
Remove the rear door speaker screws (A).
Disconnect the harness connector (B) from the rear door
speaker (1) and remove.
INSTALLATION
Installation is in the r ...
Power supply and ground circuit
BCM
BCM : Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuses or fusible link are blown.
2. CHECK POWER SUPPLY CIRCUIT
Turn ignition switch OFF.
Disconnect BCM.
Check voltage between BCM harness connector and ground.
3. CHECK GROUND CIRCUIT
Che ...