Diagnosis Procedure
1.CHECK CONNECTOR
2.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

3.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
Check the continuity between the harness connector and the data link connector.

Main line between DLC and HVAC circuitIgnition signal
Description
The ignition signal from the ECM is sent to and amplified by the power
transistor. The power transistor turns
ON and OFF the ignition coil primary circuit. This ON/OFF operation induces the
proper high voltage in the coil
secondary circuit.
Component Function Check
1.INSPECTIO ...
Unit disassembly and assembly
FRONT DRIVE SHAFT
Disassembly and Assembly (LH)
Circlip
Dust shield
Housing
Snap ring
Spider assembly
Stopper ring
Boot band
Boot
Shaft
Damper band
Dynamic damper
Circlip
. Joint sub-assembly : Wheel side
: Fill us ...
Filament
Inspection and Repair
INSPECTION
When measuring voltage, wrap tin foil around the top of the
negative
probe. Then press the foil against the wire with your finger.
Attach probe circuit tester (in Volt range) to middle portion of
each filament.
If a filament is burne ...