Nissan Maxima Service and Repair Manual: DTC/circuit diagnosis

CAN communication circuit

Diagnosis Procedure 1.CONNECTOR INSPECTION Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Disconnect all the unit connectors on CAN communication syste ...

Main line between ADP and DLC circuit

Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and ...

Other materials:

C1142 press sen circuit
Description The pressure sensor converts the brake fluid pressure to an electric signal and transmits it to the ABS actuator and electric unit (control unit). (The pressure sensor is integrated in the ABS actuator and electric unit (control unit).) DTC Logic DTC DETECTION LOGIC DTC C ...

Unlocking doors
1. Press the   button on the Intelligent Key. 2. The driver's door will unlock and the hazard warning lights flash once, and the front and tail lights will turn on for 30 seconds. 3. Press the  button again within one minute, the outside buzzer sounds once and the remai ...

Steering switch
Removal and Installation REMOVAL Remove the driver airbag module. Refer to SR-12, "Removal and Installation". Remove the steering wheel audio control switch screws (A). Release the steering wheel audio control switch harness clips (B). Remove the steering wheel audio control switche ...