Nissan Maxima Service and Repair Manual: Main line between A-bag and ABS circuit

Main line between HVAC and A-bag circuit

Diagnosis Procedure 1.CHECK HARNESS CONTINUITY (OPEN CIRCUIT) Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Disconnect the following harness connector ...

ECM branch line circuit

Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and ...

Other materials:

System maintenance
The two radar sensors 1 for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused b ...

Outside the vehicle
The maintenance items listed here should be performed from time to time, unless otherwise specified. Doors and engine hood: Check that the doors and engine hood operate properly. Also ensure that all latches lock securely. Lubricate hinges, latches, latch pins, rollers and links if necessary ...

B210D starter relay
DTC Logic DTC DETECTION LOGIC NOTE: If DTC B210D is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-29, "DTC Logic". If DTC B210D is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-30, "D ...