Nissan Maxima Service and Repair Manual: Periodic maintenance
WHEEL HUB
On-vehicle Service
Check axle and suspension parts for excessive play, wear or damage.
- Shake each rear wheel to check for excessive play.
Inspection
Rear Wheel Bearing
- Check axial end play.
Axial end play : Refer to RAX-8, "Wheel Bearing (Rear)".
- Check that wheel hub bearings operate smoothly.
- Replace wheel bearing assembly if there is axial end play or wheel bearing does not turn smoothly. Refer to FAX-7, "Removal and Installation".
Symptom diagnosis
NOISE, VIBRATION, AND HARSHNESS(NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use the chart below to help you find the cause of the symptom. If necessary,
repair or replace these parts.
&tim ...
Removal and installation
WHEEL HUB
Removal and Installation
Knuckle
Baffle plate
Wheel hub assembly
Brake rotor
Wheel nut
Anchor block
Wheel sensor
Parking brake cable
Refer to PB-6, ...
Other materials:
Illumination
Wiring Diagram
...
P0506 ISC system
Description
The ECM controls the engine idle speed to a specified level via the fine
adjustment of the air, which is let into
the intake manifold, by operating the electric throttle control actuator. The
operating of the throttle valve is varied
to allow for optimum control of the engine id ...
BCM branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative
terminal.
Check the terminals and connectors of the BCM
for damage, bend and loose connection (unit side and
connector side).
2. ...
Nissan Maxima Owners Manual
- Illustrated table of contents
- Safety-Seats, seat belts and supplemental restraint system
- Instruments and controls
- Pre-driving checks and adjustments
- Monitor, climate, audio, phone and voice recognition systems
- Starting and driving
- In case of emergency
- Appearance and care
- Do-it-yourself
- Maintenance and schedules
- Technical and consumer information
Nissan Maxima Service and Repair Manual
0.0167