Description
DTC B1209 - B1210 COLLISION DETECTION
The air bag diagnosis sensor unit will set this DTC if it has detected a
collision which has resulted in a frontal
or side deployment of one or more
air bags or pre-tensioners. If this DTC is detected after a SRS repair, the air
bag diagnosis sensor unit has not yet been replaced. This DTC can not be erased.
PART LOCATION
DTC Logic
DTC DETECTION LOGIC
With CONSULT

DTC CONFIRMATION PROCEDURE (With CONSULT)
1.INSPECTION START
Turn ignition switch ON.
2.CHECK SELF-DIAG RESULT
Check for the DTC on CONSULT.
Diagnosis Procedure
B1017 - B1022 occupant classification system
ECU diagnosis informationMOD system limitations
WARNING
Listed below are the system limitations for
MOD. Failure to operate the vehicle in
accordance with these system limitations
could result in serious injury or death.
Do not use the MOD system when towing
a trailer. The system may not function
properly.
Excessive noise (for examp ...
P1715 input speed sensor
Description
ECM receives input speed sensor signal from TCM via the CAN communication
line. ECM uses this signal for
engine control.
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P1715 is displayed with DTC UXXXX first perform the
trouble diagnosis for DTC UXXXX. Refer
to EC-161 ...
Memory function does not operate
Component Function Check
Symptom
Memory function does not operate normally.
The setting is not maintained. (It returns to the initial
condition.)
1.CHECK OPERATION
Set temperature control switch to 32C (90F).
Press the OFF switch.
Turn the ignition switch OFF.
Turn the ignitio ...