Nissan Maxima Service and Repair Manual: Removal and installation

Basic inspection

COMPONENT INSPECTION Inspection AFTER A COLLISION WARNING: Inspect all seat belt assemblies including retractors and attaching hardware after any collision. NISSAN/INFINITI recommends that all s ...

Front seat belt

Exploded View D-ring anchor Adjustable upper anchor cover Seat belt buckle Seat belt buckle connector Lower anchor bolt cover Seat belt pre-tensioner connector Seat belt retracto ...

Other materials:

High-mounted stop lamp
Exploded View High-mounted stop lamp cover High-mounted stop lamp bulb Removal and Installation REMOVAL Slide the high-mounted stop lamp rearward on the parcel shelf to give clearance to the front locking tabs. Lift the front of the high-mounted stop lamp up and slide it forward ...

Front door speaker
Removal and Installation REMOVAL Remove the front door finisher. Refer to INT-18, "Removal and Installation". Remove the front door speaker screws (A). Disconnect the harness connector from the front door speaker (1) and remove. Remove the front door speaker spacer screws (B) and ...

B2608 starter relay
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2608 is displ ...