Nissan Maxima Service and Repair Manual: Memory function does not operate

Component Function Check

Symptom

  • Memory function does not operate normally.
  • The setting is not maintained. (It returns to the initial condition.)

1.CHECK OPERATION

  1. Set temperature control dial to 32C (90F).
  2. Press the OFF switch.
  3. Turn the ignition switch OFF.
  4. Turn the ignition switch ON.
  5. Press the AUTO switch.
  6. Check that the set temperature is maintained.
    Noise
    Component Function Check Symptom Noise Noise is heard when the A/C system operates. INSPECTION FLOW ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", ...

    Other materials:

    Vehicle Dynamic Control (VDC) off switch
    The vehicle should be driven with the VDC system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The engine speed will be reduced even if the accelerator is depressed to the floor. If maximum engine po ...

    Vehicle information display warnings and indicators
    No Key Detected Key ID Incorrect Key Battery Low I-Key System Error: See Owner's Manual Shift to Park Push brake and start switch to drive Engine start operation for Intelligent Key system (if I-Key battery level is low) Release Parking Brake Low Fuel Low Washer Fluid Ti ...

    ECM branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR  Turn the ignition switch OFF.  Disconnect the battery cable from the negative terminal.  Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). &nb ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0116