Wiring diagram
Insufficient coolingSubwoofer AMP
Removal and Installation
Subwoofer amp. and bracket
Subwoofer amp. bracket screws
REMOVAL
Disconnect the battery negative terminal. Refer to PG-67, "Removal
and Installation (Battery)".
Remove the parcel shelf finisher. Refer to INT-28, "Removal and
Installation". NOTE: The ...
System maintenance
The two radar sensors 1 for the BSW and
RCTA systems are located near the rear bumper.
Always keep the area near the radar sensors
clean.
The radar sensors may be blocked by temporary
ambient conditions such as splashing water, mist
or fog.
The blocked condition may also be caused b ...
Unlock sensor
Description
Detects door lock condition of driver door.
Component Function Check
1. CHECK FUNCTION
With CONSULT
Check unlock sensor UNLK SEN−DR in "Data Monitor" mode.
Diagnosis Procedure
1. CHECK UNLOCK SENSOR POWER SUPPLY
Check signal between BCM connector and ground with o ...