Nissan Maxima Owners Manual: Dehumidified defrosting or defogging

1. Press the  front defroster button on.

2. Turn the temperature control dial to set the maximum temperature to aid in defrosting or defogging.

  • To quickly remove ice from the outside of the windows, use the fan speed control buttons to set the fan speed to maximum.
  • As soon as possible after the windshield is clean, press the AUTO button to return to the automatic mode.
  • When the front defroster button is pressed, the air conditioner will automatically be turned on at outside temperatures above 36F (2C). The air recirculate mode automatically turns off, allowing outside air to be drawn into the passenger compartment to further improve the defogging performance.

    When the air recirculate mode automatically turns off, the air fresh mode will automatically turn on.

Remote engine start logic

Vehicles equipped with automatic climate controls and remote start function may go into automatic heating or cooling mode when remote start is activated depending on outside and cabin temperatures.

Automatic temperature depends on outside and cabin temperatures. During this period, the climate control display and buttons will be inoperable until the ignition switch is turned on.

    Heating (A/C OFF)
    The air conditioner does not activate. When you need to heat only, use this mode. 1. Press the AUTO button. 2. Turn the temperature control dial to set the desired temperature. The tempera ...

    Manual operation
    Fan speed control Press the fan speed control buttons to manually control the fan speed. Press the AUTO button to return to automatic control of the fan speed. Air recirculation Press the&n ...

    Other materials:

    P1720 VSS
    Description ECM receives two vehicle speed signals via the CAN communication line. One is sent from "ABS actuator and electric unit (control unit)" via the combination meter, and the other is from TCM (Transmission control module). ECM uses these signals for engine control. DTC Logic DTC ...

    Meter control switch
    Removal and Installation REMOVAL  Disconnect the negative battery terminal. Refer to PG-67, "Removal and Installation (Battery)".  Remove the cluster lid A. Refer to IP-16, "Removal and Installation".  Detach the combination meter control switch harnes ...

    C1708 - C1711 data from transmitter not being received
    Description Tire pressure data for one or more transmitters is not being received by the BCM. DTC Logic NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.  Activate and display T ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0097