Nissan Maxima Owners Manual: Car phone or CB radio

When installing a CB, ham radio or car phone in your vehicle, be sure to observe the following precautions; otherwise, the new equipment may adversely affect the engine control system and other electronic parts.

WARNING

  • A cellular phone should not be used for any purpose while driving so full attention may be given to vehicle operation.

    Some jurisdictions prohibit the use of cellular phones while driving.

  • If you must make a call while your vehicle is in motion, the hands free cellular phone operational mode (if so equipped) is highly recommended. Exercise extreme caution at all times so full attention may be given to vehicle operation.
  • If you are unable to devote full attention to vehicle operation while talking on the phone, pull off the road to a safe location and stop your vehicle.

CAUTION

  • Keep the antenna as far away as possible from the electronic control modules.
  • Keep the antenna wire more than 8 in (20 cm) away from the electronic control system harnesses. Do not route the antenna wire next to any harness.
  • Adjust the antenna standing-wave ratio as recommended by the manufacturer.
  • Connect the ground wire from the CB radio chassis to the body.
  • For additional information, it is recommended that you visit a NISSAN dealer.

Bluetooth Hands-Free Phone System

For additional information, refer to the separate Navigation Owner's Manual.

NISSAN Voice Recognition System

For additional information, refer to the separate Navigation Owner's Manual.

    NissanConnectSM Services (if so equipped)
    NissanConnectSM Services is a suite of telematics tools that provide emergency preparedness, remote access, customizable alerts and convenience services. This feature is an option on Navigation eq ...

    Starting and driving
    ...

    Other materials:

    Programming HomeLink for Canadian customers and gate openers
    Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission - which may not be long enough for HomeLink to pick up the signal during training. Similar to this Canadian law, some U.S. gate operators are designed to "timeout" in the sam ...

    P0122, P0123 TP sensor
    Description Electric throttle control actuator consists of throttle control motor, throttle position sensor, etc. The throttle position sensor responds to the throttle valve movement. The throttle position sensor has two sensors. These sensors are a kind of potentiometer which transfor ...

    B2614 ACC relay circuit
    Description BCM controls the various electrical components and simultaneously supplies power according to the power supply position. BCM checks the power supply position internally. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. PERFORM DTC CONFIRMATION PROCEDURE Tur ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0106