Nissan Maxima Service and Repair Manual: The door open warning continues displaying, or does not display

Description

  •  The door ajar warning is displayed even though all of the doors and the trunk are closed.

  •  The door ajar warning is not displayed even though a door or the trunk is ajar.

Diagnosis Procedure

1.CHECK BCM INPUT SIGNAL

Connect CONSULT and check the BCM input signals. Refer to DLK-67, "Component Function Check" (Door switch) and DLK-88, "Component Function Check" (Trunk lamp switch and truck release solenoid).

2.CHECK COMBINATION METER INPUT SIGNAL

  1.  Select "METER/M&A" on CONSULT.

  2.  Monitor "DOOR W/L" and "TRUNK/GLAS-H" of "DATA MONITOR" while opening and closing doors and trunk.

3.CHECK DOOR SWITCH SIGNAL CIRCUIT

Check the door switch signal circuit. Refer to DLK-67, "Diagnosis Procedure".

4.CHECK DOOR SWITCH UNIT

Perform a unit check for the door switch. Refer to DLK-69, "Component Inspection".

5.CHECK TRUNK LAMP SWITCH AND TRUNK RELEASE SOLENOID SIGNAL CIRCUIT

Check the trunk lamp switch and trunk release solenoid signal circuit. Refer to DLK-88, "Diagnosis Procedure".

6.CHECK TRUNK LAMP SWITCH AND TRUNK RELEASE SOLENOID UNIT

Perform a unit check for the trunk lamp switch and trunk release solenoid. Refer to DLK-90, "Component Inspection".

    The low washer fluid warning continues displaying, or does not display
    Description  The warning is still displayed even after washer fluid is added.  The warning is not displayed even though the washer tank is empty. Diagnosis Procedu ...

    The ambient temperature display is incorrect
    Description  The displayed ambient air temperature is higher than the actual temperature.  The displayed ambient air temperature is lower than the actual temperature. ...

    Other materials:

    Diagnosis system (BCM)
    CONSULT Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions. CONSULT Function (BCM - AIR PRESSURE MONITOR) NOTE: The Signal Tech II Tool (J-50190) can be used to ...

    Oil Seal
    Removal and Installation of Valve Oil Seal REMOVAL Turn crankshaft until the cylinder requiring new oil seals is at TDC. This will prevent valve from dropping into cylinder. CAUTION: When rotating crankshaft, be careful to avoid scarring the front cover with the timing chain. Remove ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0106