Nissan Maxima Service and Repair Manual: The low washer fluid warning continues displaying, or does not display

Nissan Maxima Service and Repair Manual / Driver information & multimedia / Meter, warning lamp & indicator / Symptom diagnosis / The low washer fluid warning continues displaying, or does not display

Description

  •  The warning is still displayed even after washer fluid is added.

  •  The warning is not displayed even though the washer tank is empty.

Diagnosis Procedure

1.CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT

Check the washer fluid level switch signal circuit. Refer to MWI-45, "Diagnosis Procedure".

2.CHECK WASHER FLUID LEVEL SWITCH UNIT

Perform a unit check for the washer fluid level switch. Refer to MWI-46, "Component Inspection".

    The parking brake release warning continues displaying, or does not display
    Description  The parking brake warning is displayed while driving the vehicle even though the parking brake is released.  The parking brake warning is not displayed even ...

    The door open warning continues displaying, or does not display
    Description  The door ajar warning is displayed even though all of the doors and the trunk are closed.  The door ajar warning is not displayed even though a door or the ...

    Other materials:

    Parking lamp circuit
    Description The IPDM E/R (intelligent power distribution module engine room) controls the tail lamp relay based on inputs from the BCM over the CAN communication lines. When the tail lamp relay is energized, power flows through fuses 46 and 47, located in the IPDM E/R. Power then flows to the ...

    Vertical synchronizing (VP) signal circuit
    Description In composite image (AUX image, camera image), transmit the vertical synchronizing (VP) signal and horizontal synchronizing (HP) signal from display unit to AV control unit so as to synchronize the RGB images displayed with AV control unit, such as the image quality adjusting men ...

    Disk eject signal circuit
    Description The eject signal is output to AV control unit when the eject switch of A/C and AV switch assembly is pressed. Diagnosis Procedure 1.CHECK CONTINUITY DISK EJECT SIGNAL CIRCUIT Turn ignition switch OFF. Disconnect A/C and AV switch assembly connector M98 and AV control un ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0094