Nissan Maxima Owners Manual: System maintenance

Nissan Maxima. System maintenance

CAUTION

  • Do not use alcohol, benzine or thinner to clean the camera. This will cause discoloration.
  • Do not damage the camera as the monitor screen may be adversely affected.

If dirt, rain or snow accumulates on the camera 1 , the RearView Monitor may not display objects clearly. Clean the camera by wiping it with a cloth dampened with a diluted mild cleaning agent and then wiping it with a dry cloth.

    RearView Monitor system limitations
    WARNING Listed below are the system limitations for RearView Monitor. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death. The s ...

    Around View Monitor (if so equipped)
    1. CAMERA button WARNING Failure to follow the warnings and instructions for the proper use of the Around View Monitor system could result in serious injury or death. The Around View ...

    Other materials:

    P0841 transmission fluid pressure SEN/SW A
    Description Using the engine load (throttle position), the primary pulley revolution speed, and the secondary pulley revolution speed as input signals, TCM changes the operating pressure of the primary pulley and the secondary pulley and changes the groove width of the pulley to control the ...

    Vents
    Side Adjust air flow direction by moving the vent slides. Open or close the vents by using the dial. Move the dial toward the   to open the vents or toward the to close them. Center Rear (center console) ...

    P050A, P050e cold start control
    Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P050A or P050E is dis ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0075