Nissan Maxima Owners Manual: How to switch the display

With the ignition switch in the ON position, press the CAMERA button or move the shift lever to the R (Reverse) position to operate the Around View Monitor.

The Around View Monitor displays different split screen views depending on the position of the shift lever. Press the CAMERA button to switch between the available views.

If the shift lever is in the R (Reverse) position, the available views are:

  • Rear view/bird's-eye view split screen
  • Rear view/front-side view split screen

If the shift lever is in the P (Park) position, the available views are:

  • Front view/bird's-eye view split screen
  • Front view/front-side view split screen

If the shift lever is in the D (Drive) position, the only available view is front view/front-side view split screen.

The display will switch from the Around View Monitor screen when:

  • The shift lever is in the D (Drive) position and the vehicle speed increases above approximately 6 mph (10 km/h)
  • A different screen is selected.
    How to park with predicted course lines
    WARNING If the tires are replaced with different sized tires, the predicted course lines may be displayed incorrectly. On a snow-covered or slippery road, there may be a difference between the p ...

    Adjusting the screen
    1. Touch the touch-screen display with the Around View Monitor on. 2. Touch the "Brightness," "Contrast," "Tint," "Color," or "Black Level" key. 3. Adjust the item by touching the + or - k ...

    Other materials:

    B2630, B2631 sunload sensor
    Description COMPONENT DESCRIPTION Sunload Sensor The sunload sensor (1) is located on the driver'side defroster grille. It detects sunload entering through windshield by means of a photo diode. The sensor converts the sunload into a current value, which is then input into the A/C auto ...

    Side air bag (satellite) sensor
    Removal and Installation CAUTION: Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 minutes. Do not use air tools or electric tools for servicing. Replace the satellite sensor of deployed SRS front side air bag and deployed SRS side ...

    Power supply and ground circuit
    BCM BCM : Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuses or fusible link are blown. 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF. Disconnect BCM. Check voltage between BCM harness connector and ground. 3. CHECK GROUND CIRCUIT Che ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0091