B26e1 no reception of engine status signal
Description
BCM receives the engine status signal from ECM via CAN
communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC B26E1 is displayed with DTC
U1000, first perform the trouble diagnosis for DTC U1000. Refer to
SEC-29, "DTC Logic".
If DTC B26E1 is displayed with D ...
The fuel gauge pointer does not move to "F" when refueling
Description
The fuel gauge needle will not move to "F" position when
refueling.
Diagnosis Procedure
1.OBSERVE FUEL GAUGE
Does it take a long time for the pointer to move to FULL
position?
2.IDENTIFY FUELING CONDITION
Was the vehicle fueled with the ignition switch ON?
3.OBSERVE VEHICLE PO ...
Hazard warning flasher switch
Push the switch on to warn other drivers when
you must stop or park under emergency conditions.
All turn signal lights flash.
WARNING
If stopping for an emergency, be sure to
move the vehicle well off the road.
Do not use the hazard warning flashers
while moving on the highway unl ...