Nissan Maxima Service and Repair Manual: Tire pressure receiver

Removal and Installation

REMOVAL

Nissan Maxima. Removal and Installation

  1. Remove instrument lower panel LH. Refer to IP-11, "Removal and Installation".
  2. Locate tire pressure receiver (1) to the right of the steering column and disconnect the harness connector from the tire pressure receiver.
  3. Remove tire pressure receiver (1) from bracket using a suitable tool to release the bracket.

INSTALLATION

Installation is in the reverse order of removal.

    Removal and installation
    ...

    Road wheel tire assembly
    Adjustment BALANCING WHEELS (ADHESIVE WEIGHT TYPE) Preparation Before Adjustment Remove inner and outer balance weights from the road wheel. Using releasing agent, remove double-faced adhesive tap ...

    Other materials:

    Microphone signal circuit
    Description Voice signals are transmitted from the microphone to the Bluetooth control unit using the microphone signal circuits. Diagnosis Procedure 1.CHECK HARNESS BETWEEN BLUETOOTH CONTROL UNIT AND MICROPHONE Turn ignition switch OFF. Disconnect Bluetooth control unit connector and ...

    B1033 - B1035 crash zone sensor
    Description DTC B1033 - B1035 CRASH ZONE SENSOR The crash zone sensor is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit willmonitor for opens and shorts in detected lines to the crash zone sensor. PART LOCATION DTC Logic DTC DETECTION LOGIC With CONSULT DT ...

    Crash zone sensor
    Component Crash zone sensor harness connector Crash zone sensor Nut Front Removal and Installation CAUTION: Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 minutes. Do not use air tools or electric tools for servicing. ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0089