Nissan Maxima Service and Repair Manual: ECM branch line circuit

Main line between A-bag and ABS circuit

Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and ...

BCM branch line circuit

Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the BCM for damage, bend and ...

Other materials:

P1722 vehicle speed
Description The vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) to TCM via CAN communication line. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: Immediately after performing any "DT ...

Mudguard
Exploded View Mudguard Clip C205 Clip CF118 Front Removal and Installation REMOVAL Remove the clips located on the underbody. Remove the center mudguard front and rear screws. Remove the rear wind deflector bolt. Refer to EXT-24, "Removal and Installation". Release t ...

Front stabilizer
Removal and Installation REMOVAL Remove the steering gear and linkage. Refer to ST-26, "Removal and Installation". Remove the nuts on the upper portion of stabilizer connecting rod Remove the stabilizer clamp bolts. Remove the front stabilizer from the vehicle INSPECTION AFTER ...