General maintenance includes those items which should be checked during normal day-to-day operation.
They are essential for proper vehicle operation.
It is your responsibility to perform these procedures regularly as prescribed.
Performing general maintenance checks requires minimal mechanical skill and only a few general automotive tools.
These checks or inspections can be done by yourself, a qualified technician or, if you prefer, a NISSAN dealer.
Scheduled maintenance
The maintenance items listed in this section are required to be serviced at regular intervals. However under severe driving conditions, additional or more frequent maintenance will be required.
Maintenance requirements
Where to go for serviceTowing recommended by NISSAN
CAUTION
Never tow CVT models with the front
wheels on the ground or 4 wheels on
the ground (forward or backward), as
this may cause serious and expensive
damage to the transmission. If it is necessary
to tow the vehicle with the rear
wheels raised always use towing dollies
under the ...
Headlamp (HI) circuit
Description
The IPDM E/R (intelligent power distribution module engine room) controls the
headlamp high relay based on inputs from the BCM over the CAN communication
lines. When the headlamp high relay is energized, power flows through fuses
48 and 49, located in the IPDM E/R. Power then flow ...
Sunload sensor
Removal and Installation
REMOVAL
Remove the front LH speaker grille from the instrument panel.
Refer to IP-10, "Exploded View".
Disconnect the harness connector from the sunload sensor.
Release the sunload sensor tabs and remove the sunload sensor
(1) from the front LH speake ...