Nissan Maxima Service and Repair Manual: Periodic maintenance

Symptom diagnosis

NOISE, VIBRATION, AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use chart below to help you find the cause of the symptom. If necessary, repair or replace these parts. × ...

Front wheel hub

Inspection Move wheel hub and bearing assembly in the axial direction by hand. Make sure there is no looseness of wheel bearing. Rotate wheel hub and make sure there are no unusual noises or ...

Other materials:

Signal buffer system
System Diagram System Description IPDM E/R reads the status of the oil pressure switch and transmits the oil pressure switch signal to BCM via CAN communication. IPDM E/R receives the rear window defogger status signal from BCM via CAN communication and transmits it to ECM via ...

Clearing the programmed information
The following procedure clears the programmed information from both buttons. Individual buttons cannot be cleared. However, individual buttons can be reprogrammed. For additional information, refer to "Reprogramming a single HomeLink button" in this section. To clear all programming: 1. Press ...

Headlamp aiming adjustment
Description PREPARATION BEFORE ADJUSTING CAUTION: Do not use organic solvent (thinner, gasoline etc.) NOTE: For details, refer to the regulations in your own country. Perform aiming adjustment if the vehicle front body has been repaired and/or the front combination lamp assembly has be ...