Nissan Maxima Service and Repair Manual: HVAC branch line circuit

Diagnosis Procedure

1.CHECK CONNECTOR

  1. Turn the ignition switch OFF.
  2. Disconnect the battery cable from the negative terminal.
  3. Check the terminals and connectors of the A/C auto amp. for damage, bend and loose connection (unit side and connector side).

2.CHECK HARNESS FOR OPEN CIRCUIT

  1. Disconnect the connector of A/C auto amp.
  2. Check the resistance between the A/C auto amp. harness connector terminals.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the A/C auto amp. Refer to the following.

  • Models with color display: HAC-60, "A/C AUTO AMP. : Diagnosis Procedure"
  • Models with monochrome display: HAC-165, "A/C AUTO AMP. : Diagnosis Procedure"
    AV branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the AV control unit for d ...

    STRG branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the steering angle sensor ...

    Other materials:

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for ...

    ICC system limitations
    WARNING Listed below are the system limitations for the ICC system. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death. The ICC system is primarily intended for use on straight, dry, open roads with light traffic. It is ...

    Headlamp
    System Diagram System Description Control of the headlamp system is dependent upon the position of the combination switch (lighting and turn signal switch). When the lighting switch is placed in the 2nd position, the BCM (body control module) receives input requesting the headlamps and par ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0082