IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)
Removal and Installation
CAUTION: Do not remove the relays from the IPDM E/R. Tampering with the relays may cause additional incidents with the vehicle.
REMOVAL



INSTALLATION
Installation is in the reverse order of removal.
Precaution
Basic inspectionGlove box
Open the glove box by pulling the handle. Use the
master key when locking or unlocking the glove
box.
There is a trunk cancel switch in the glove box.
For additional information, refer to "Cancel
switch" in the "Pre-driving checks and adjustments"
section of this manual.
WARNING
Keep g ...
Power supply and ground circuit
BCM
BCM : Diagnosis Proce
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuses or fusible link are blow
2. CHECK POWER SUPPLY CIRCUIT
Turn ignition switch OFF.
Disconnect BCM.
Check voltage between BCM harness connector and ground.
3. CHECK GROUND CIRCUIT
Check con ...
Front door speaker
Removal and Installation
REMOVAL
Remove the front door finisher. Refer to INT-18, "Removal and
Installation".
Remove the front door speaker screws (A).
Disconnect the harness connector from the front door speaker
(1) and remove.
Remove the front door speaker spacer screws (B) and ...