NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use chart below to help you find the cause of the symptom. If necessary, repair or replace these parts.

×: Applicable
Wiring diagram
PrecautionEVAP control system pressure sensor
Removal and Installation
REMOVAL
Remove rear stabilizer bar clamps and position rear stabilizer bar
aside. Refer to RSU-13, "Removal and Installation".
Disconnect EVAP hose from EVAP canister.
Disconnect EVAP control system pressure sensor.
Remove EVAP control s ...
Turning the PFCW system on/off
Perform the following steps to turn the PFCW
system ON or OFF.
1. Press the button until
"Settings" displays
in the vehicle information display and
then press OK button. Use the button
to select "Driver Assistance". Then press the
OK button.
2. Select "Emergency Brake" and pr ...
Tilt&telescopic switch
Removal and Installation
REMOVAL
Remove the steering column side cover (LH) (1). Refer to IP-13,
"Removal and Installation".
Release the pawls and remove tilt & telescopic switch (2) from
the steering column side cover (LH) (1).
: Pawl
INSTALLATION
Installation is in the re ...