Nissan Maxima Service and Repair Manual: B2130 eeprom

DTC Logic

DTC DETECTION LOGIC

DTC No. Trouble diagnosis name DTC detecting condition Possible cause
B2130 EEPROM Driver seat control unit detected CPU malfunction
  • Driver seat control unit

DTC CONFIRMATION PROCEDURE

1. PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.
  2. Check "Self diagnostic result" with CONSULT.

Is the DTC is detects?

Diagnosis Procedure

1. PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.
  2. Check "Self diagnostic result" with CONSULT.
  3. Erase the DTC.
  4. Perform DTC confirmation procedure. Refer to ADP-38, "DTC Logic".

Is the DTC displayed again?

2. REPLACE DRIVER SEAT CONTROL UNIT

Replace driver seat control unit. Refer to ADP-169, "Removal and Installation".

    U1010 control unit (CAN)
    Description Refer to LAN-24, "CAN Communication Signal Chart". DTC Logic DTC DETECTION LOGIC DTC No. Trouble diagnosis name DTC detecting condition Possible cause U1010 ...

    B2112 sliding motor
    Description The seat sliding motor is installed to the seat frame. The seat sliding motor is activated with the driver seat control unit. Slides the seat forward/backward by changing the rotat ...

    Other materials:

    Center speaker
    Removal and Installation REMOVAL Remove the center speaker grille, using a suitable tool. Remove the center speaker screws (A). Pull out the center speaker (1), disconnect the harness connector from the center speaker and remove. INSTALLATION Installation is in the reverse order ...

    Engine block heater (if so equipped)
    Engine block heaters are used to assist with cold temperature starting. The engine block heater should be used when the outside temperature is 20F (-7C) or lower. WARNING Do not use your engine block heater with an ungrounded electrical system or a 2-pronged adapter. You can be serious ...

    Install
    1. Align the head restraint/headrest stalks with the holes in the seat. Make sure that the head restraint/headrest is facing the correct direction. The stalk with the notch (notches) 1 must be installed in the hole with the lock knob 2 . 2. Push and hold the lock knob and push the head re ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2022 Copyright www.nimainfo.com
    0.0053