Nissan Maxima Service and Repair Manual: Refrigerant pressure sensor

Removal and Installation

REMOVAL

  1. Discharge the refrigerant. Refer to HA-28, "Recycle Refrigerant".
  2. Remove the core support upper cover.
  3. Disconnect the harness connector from the refrigerant pressure sensor.
  4. Remove the refrigerant pressure sensor.

CAUTION: Cap or wrap the opening of the refrigerant pressure sensor with suitable material such as vinyl tape to avoid the entry of air.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Do not reuse O-ring.
  • Apply A/C oil to the O-ring of the refrigerant pressure sensor for installation.
  • After charging refrigerant, check for leaks. Refer to HA-26, "Leak Test".
    Intake sensor
    Removal and Installation REMOVAL Remove the evaporator (2). Refer to HA-48, "EVAPORATOR: Removal and Installation". Release the intake sensor clip (A), then remove the intake sensor ...

    Door motor
    Exploded View Heating and cooling unit assembly Mode door motor Air mix door motor (driver side) Air mix door motor (passenger side) Intake door motor INTAKE DOOR MOTOR INTAKE D ...

    Other materials:

    Door lock function symptoms
    DOOR LOCK AND UNLOCK SWITCH DOOR LOCK AND UNLOCK SWITCH : Symptom Table DOOR LOCK/UNLOCK FUNCTION MALFUNCTION NOTE: Before performing the diagnosis in the following table, check "WORK FLOW". Refer to DLK-9, "Work Flow". Check that vehicle is under the condition shown in "Condi ...

    Intelligent key system/engine start function
    Wiring Diagram                     ...

    BCM branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the BCM for damage, bend and loose connection (unit side and connector side). 2.CHECK HARNESS FOR OPEN CIRCUIT Disc ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0133